Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
running "mac" without arguments = endless cycle
I noticed when running a "mac" command without parameters (to be clear: only the "mac" command), results in an endless cycle of: "Warning (RT) in ... Launching macro from". Normally a user would not run it empty (no arguments).
I also tested this in a clean portable version of QM (the state in which QM is, immediately after a clean installation).
From mac help:
Quote:macro - QM item name (full, case insensitive) or id (integer).
•If omitted or "" - QM item that is currently open in the code editor.
Macro Macro2795
Copy      Help

;If you run this macro from QM with the Run button, mac will start this macro again when this macro ends. Endless loop.
ai :oops:
Sorry about this, the warning was right there.

Forum Jump:

Users browsing this thread: 1 Guest(s)