08-24-2007, 04:54 AM
Hello, im using the net command to run a macro on a computer downstairs at a certain time from my pc in my room, everytime i run it it says,
Error (RT) in Macro: could not launch
what could be the problem?
This is my code,
And on the other pc i just have a toolbar called tools, and i have correct ip address and correct password? am i forgetting something?
*Note i change ip address and password to post it here.
Error (RT) in Macro: could not launch
what could be the problem?
This is my code,
str c("111.111.1.11") p("pw") m("tools")
if(NetSendMacro(c p m)) end "could not send"
if(net(c p m)) end "could not launch"
And on the other pc i just have a toolbar called tools, and i have correct ip address and correct password? am i forgetting something?
*Note i change ip address and password to post it here.