04-03-2007, 10:51 PM
I have a gas sensor system which I want to integrate so I don't have to spend hours running the system. The system has mass flow controllers and a program which controls how much amount of gas I want to flow through these contollers. One more program controls the switches for the valves so that I can flow certain gases. Another program controls the multimeter which measures the resisatnce across multiple channels.
What do I want? I want to know if quick macros can do the following!!!
I want to setup a program, which flows different gases at different flow rates.So I need the program to do this
step 1 flow 50% Gas1( set flow rate to 50% as well as turn on gas valve to flow 50% gas1)
step 2: flow 2% gas2 and 50% gas 1(set flow rate of gas2 to 2%, gas1 at 50%), open valve to flow both gases!!!
so i have plenty of steps like this and when the gas flow turns on, I need to tell the keithley to record data......and stop after I have gone through my gas pulses. Ia this possible on quick macros 2? Pleas elet me know if this is possible!!!
What do I want? I want to know if quick macros can do the following!!!
I want to setup a program, which flows different gases at different flow rates.So I need the program to do this
step 1 flow 50% Gas1( set flow rate to 50% as well as turn on gas valve to flow 50% gas1)
step 2: flow 2% gas2 and 50% gas 1(set flow rate of gas2 to 2%, gas1 at 50%), open valve to flow both gases!!!
so i have plenty of steps like this and when the gas flow turns on, I need to tell the keithley to record data......and stop after I have gone through my gas pulses. Ia this possible on quick macros 2? Pleas elet me know if this is possible!!!